Viper Responder One Owner Manual - Page 8
Battery Replacement
View all Viper Responder One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
➢ Battery ReplacemElaestnomt er contact Front Front Elastomer 1. Using a cosnmtaactll slotted screEwlcaos-ntotamcter driver, insert into slot located on the side of the unit as shown and carefully pry the front of the unit up, Elastomer workFrionngt until the your front way around the edgeCircuit BoacrodntacEtlastomer is completely separat- contact ed from the housing. Note: MakeFrosnut re that the small elas- tomer contact located inside the un+it as shown does not fall out during the replaceEmlcaoesntnotamtctepr rocess. 2. Turn the circuit board over, remove batterieEslasftroommer clip and replace. contact Circuit Board ++ + ++ Note: Verify that the battery polarity is correct when replac- ing. Batteries are stacked in series and polarity is indicated. 3. Reposition all parts and snap together. 8 © 2008 Directed Electronics. All rights reserved.