Viper 3903V Owner Manual - Page 9

Disarming To disarm the system, unlock the doors using your factory keyless transmitter. The siren will sound twice, and the parking lights will flash twice. If the siren sounds either four or five times when disarming, refer to the Diagnostics section of this guide. This is called Tamper Alert. Disarming without a transmitter This feature allows you to override the system without the transmitter should it be lost, damaged or disabled. To do this, you must have the vehicle's ignition key and know where the integrated LED/Valet® switch is located. The Valet® switch is activated by pressing the LED status indicator. Integrated LED/Valet® switch LED status indicator Turn the ignition to the "run"position. Press and release the integrated LED/Valet® switch, within 10 seconds. After a few seconds the LED will stop DRW-35 flashing and the vehicle should start. If it does not, you may have waited too long. Turn the ignition off and try again. note: The setting for the number of times the integrated LED/Valet® switch must be pressed is set in the Programming Section of this guide. 6 © 2007 Directed Electronics-all rights reserved