Viking FDRB5302R Use and Care Manual - Page 10

Operation All Freezer Door Bin Adjustment Your appliance's door bins hold two-liter bottles and can be placed in any position on the refrigerator door. To remove a bin, simply 2 grasp it, lift the bin up, and pull it out. 1 To replace the bin, place it over the glides in the door, and push the door bin down to lock it into place. Wire Shelf Adjustment You can easily adjust your freezer's shelves. To remove a shelf, simply tilt it up at the front, releasing the hooks from the shelf support. Then, pull the shelf straight out. To replace, guide the rear hooks of the shelf into the slots in the shelf supports. Then, tilt the shelf up at the front until the hooks drop into the slots. Next, lower the front of the shelf to a level position. Wire Basket Adjustment You can easily adjust your freezer's wire baskets by moving the dividers. To remove a divider, simply grasp it in the center, and pull the divider straight up. To replace, guide the divider around the basket wires in the desired location, then push the divider down until it stops. 18 Automatic Ice Maker (All Freezer) The ice maker and slide-out ice drawer on your refrigerator are not adjustable, but the ice drawer slides forward for easy access to ice. After the freezer reaches normal temperature, the ice maker fills with water and begins operating. Under normal conditions, the ice maker will produce seven to nine batches of ice per 24 hour period. NOTE: Allow 24 to 48 hours after installation before looking for ice in your ice drawer. You should discard the first three full drawers of ice and should also throw out the first drawer full of ice after extended periods of non-use. During ice production, the ice maker arm raises and lowers. When the ice bin is full, the ice maker arm automatically turns the ice maker off. To manually stop ice production, raise the ice maker arm. You will hear a definite click when you have the arm in the right position. The ice maker won't produce any more ice until you lower the ice maker arm. On Position Ice Maker Arm Off Position CAUTION To avoid damage to ice maker, observe the following: • Do not force ice maker arm down or up past stop position. • Do not place or store anything in ice bucket. 19 Operation