URC MXHP-H500 Owners Manual - Page 14
Network Installation
View all URC MXHP-H500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Network Installation The hub can be installed using Wi-Fi or an Ethernet connection, keep in mind the initial programming must be performed with a wired connection. When being installed for the first time, one of the two following steps must be followed: Wired Ethernet Connect the hub to the router using the supplied Ethernet cable. See image below for proper Ethernet placement. OR Wireless (Wi-Fi) 1. Connect the hub to the wireless access point by using the WPS button (page 10) and pressing the same button on the wireless access point/router 2. If successfully connected, the Wi-Fi LED glows blue, green, yellow, or red based on the signal strength (page 8) Setup is now complete, if you wish to set specific network settings, see the following section. When the Status LED illuminates red, use the remote control or mobile app to set the network properties of the hub (see MX-HomePro Installation Guide). Make sure the remote control or mobile app are on the same network that the hub is hard wired into. To set the network properties of the hub, insert the battery into the remote control and follow the on-screen prompts (for more details refer to the MX-HomePro Installation Guide). Page 11