Toshiba TLP-WX2200U Owners Manual - Page 24

Lamp replacement (Continued) 5 Mount the new lamp. 5 2 Align the orientation, press down the new lamp until the bottom is reached, and lock in place using 1 the three lamp locking screws. 6 Replace the lamp cover. Align the cover, and press it in, then tighten the screws loosened in step 3 until the lamp cover is no longer loose. 7 Reset the lamp time. See the lamp's manual for instructions on resetting the lamp time. Notes and Precautions • The [Lamp time] item in the Status display menu indicates the time of lamp use (as a rough guide) p.43 • Please replace the lamp after 2000 hours of use with [Lamp power] in the Default setting 1 menu set to [Standard], and 3000 hours of use with [Lamp power] in the Default setting 1 menu set to [Low]. p.41 • There are cases that the lamp can not work before the above mentioned period expires or before the replacement message is displayed. • Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the projector may fail to be powered on or the lamp may fail to come on. • Always replace the lamp with a new one. • The lamp is made out of glass. Do not touch the glass surface with your bare hands, bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.) About lamp replacement messages • The lamp replacement message of this projector displays an appropriate period according to the use period for [Standard] / [Low] of the [Lamp power] respectively. • When the replacement time approaches, the message of "The lamp life is ending. Please change the lamp." and the icon are displayed every time the power is turned on. This display disappears when you press the button. Used Lamps This projector's lamps contain trace amounts of environmentally harmful inorganic mercury. Be careful not to break used lamps, and dispose of them in accordance with local regulations. 46 Air filter cleaning The air filter prevents dust and debris from getting inside the projector. Never run the projector with the filter removed. It is recommended that the air filter is cleaned regularly. • The message "Check the air filter for dirt." is displayed every 100 hours. (If the usage time exceeds 100 hours, this message is displayed for about 30 seconds when the image is displayed for the first time after power is turned on. This display will be dismissed with any operation.) • Check out the filter and any debris is found, use the following procedure for cleaning. WARNING • Request cleaning and maintenance of a ceiling-mounted unit from your projector dealership. 1 Unplug power cord. 2 Remove the air filter. Pull out the air filter by taking the catch shown in the figure. 3 Clean the filter. Carefully remove the dust and dirt from the air filter with a vacuum cleaner or the like. 4 Replace the air filter. Notes • Allowing dirt and dust to build up in the air filter will worsen the air circulation inside the projector, causing the internal temperature to rise, causing the projector to stop working or malfunction. • Insert the air filter all the way in. Leaving gaps will allow dust and dirt to get inside the projector again. • If you wash the air filer with water, make sure to dry it completely before replacing it. • If the air filter is torn, consult with your dealer about replacing it with a new one. Continuing to use a ripped filter will allow dust and dirt to get inside the projector. 47 Maintenance