TASCAM VS-R264 How to Stream to an Online Platform You Tube RTMP etc English - Page 5

VS-R264 / VS-R265 Streaming Point-to-point When you need to send a stream from a specific encoder to a specific decoder. Streaming Point-to-Point with a VS-R264/VS-R265 (Unicast) For point-to-point streaming with VS-R264/VS-R265 as both the encode and decode side, see "Streaming Point-to-Point between VSR264/VS-R265 (Unicast)" on page 6. Unicast Setting up the encoder 1. Connect to the VS-R264/VS-R265. 2. Navigate to Encoder Control in the Streaming Dashboard. 3. Click Configure under Output Settings. 4. Click the Unicast tab. 5. Under either Unicast Output A or B. 1 Choose rtp or udp based on Unicast streaming tips. 2 Enter the decoder's IP into the IP Address field. 3 Enter the port to stream on into the Port field (more information on this also in Unicast streaming tips). 6. Click the On/Off switch next to Unicast Output A or B to ON. 7. Click either OK or Apply. A common decoder used in testing is VLC. Simply go to "Open network stream" and enter [rtp or udp]://@:[PORT], click Play, and you should see your stream. Setting up the decoder 1. Connect to the VS-R264/VS-R265. 2. Navigate to Decoder Control in the Streaming Dashboard. 3. Click Configure under Stream Settings. 4. Choose Other Encoder for Source Encoder. 5. Select Unicast as Stream Type. 6. Choose rtp or udp for Protocol to match which was chosen when setting up the encoder. 7. Enter the port being streamed on into the Port field. 5 TASCAM VS-R264 / VS-R265