Stihl TS 420 STIHL Cutquik174 Product Instruction Manual - Page 14
Wet Cutting with Abrasive Wheels, WARNING, Reactive Forces including Kickback, Pull-away, Climbing,
![]() |
View all Stihl TS 420 STIHL Cutquik174 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
002BA553 AM English power available for the actual cutting work. It could also damage the abrasive wheel. STIHL recommends the use of the cart for longer cuts in a straight line. Wet Cutting with Abrasive Wheels Before wet cutting, make sure water will not damage the floor or building. WARNING To reduce the risk of electrocution to you or bystanders, do not allow water or sludge to contact live electric wires. WARNING To reduce the risk of injury from wheel breakage when wet cutting with any composite wheel: 1. Make certain water does not flow on a wheel that is not running, since the wheel will absorb water, which will affect wheel balance. 2. Be certain water is applied to both sides of wheel, since uneven distribution can cause "one sided" wear. 3. After finishing work, run the cutting wheel at normal operating speed for about 3 to 6 seconds without water so that the remaining water is flung off. WARNING To reduce the risk of injury from wheel breakage when wet cutting with a composite wheel that is not specifically designed for wet cutting, never store and reuse such a wheel that has been used with water. Use these wheels up the same day. Reactive Forces including Kickback WARNING Reactive forces may occur at any time the cutting wheel on a cut-off machine is rotating. The powerful force used to cut through a workpiece can be reversed and work against the operator. If the wheel is slowed or stopped by frictional contact with any solid object or by a pinch or binding, reactive forces can occur instantly and may result in the operator losing control of the cut-off machine, which, in turn, may result in serious or fatal injury. An understanding of the causes of these reactive forces may help you avoid loss of control. Reactive forces are exerted in a direction opposite to the direction in which the wheel is moving at the point of contact or of pinching/binding. If the wheel is slowed solely by frictional contact with a solid object, such as the workpiece, the resulting reactive forces are normally moderate and readily controllable by an operator who is holding the machine properly. If, however, the wheel is abruptly slowed or stopped by a pinch or severe bind, the reactive forces may be substantially greater. The greater the force generated, the more difficult it will be for the operator to control the cut-off machine. Loss of control can result in severe personal injury or death. Pull-away, Climbing, Pinching and Rotational Kickback Forces The most common reactive forces are pull-away and climbing. If the contact is at the bottom of the wheel, a cut-off machine will try to pull away from the operator (pull-away.) If the contact is at the front of the wheel, the wheel may attempt to climb the object being cut (climbing.) Pinching occurs when the piece being cut closes on the wheel. A severe binding may also occur if the wheel is substantially sideloaded in the kerf or if an improper or damaged diamond wheel begins or ceases to wobble in the kerf. If the wheel is severely pinched or bound in the upper quadrant, the wheel may be instantly thrown up and back towards the operator with great force in a rotational kickback motion. Such kickback situations can and should always be avoided. Pinching of the wheel can be prevented by proper support of the workpiece. (See below.) Severe binding of the wheel can be prevented by proper cutting techniques, e.g., not sideloading the wheel, and by the use of properly designed, manufactured and maintained wheels. 12 TS 410, TS 420
![](/manual_guide/products/stihl-ts-410-stihl-cutquik174-product-instruction-manual-2e19b9e/14.png)