Stihl TS 410 STIHL Cutquik Product Instruction Manual - Page 34

English ground or any objects. There must not be anyone within the swivel range of the cut-off machine N Make sure you have a firm footing N Press the cut-off machine firmly against the ground, holding the handle with your left hand, thumb wrapped round the handle N Place your right foot on the shroud N Pull the starter grip slowly with your right hand until you feel it engage - then give it a brisk strong pull - do not pull out the starter rope all the way Do not let the starter grip snap back - it may break! Guide it back into the housing in the opposite direction so that it can rewind properly. When the engine has turned over for the first time 4 Choke Once the engine is running N Squeeze throttle trigger fully and let engine run at full throttle for approx. 30 s N When it has warmed up, set the choke lever to e 3 START N The slide control (3) moves to the normal positionF when the throttle trigger is squeezed If the carburetor has been set correctly, the cutting wheel should not rotate when the engine is idling. The cut-off machine is now ready for use. Switch off engine 370BA058 KN Additional hints on starting If the engine does not start The choke lever was not returned to f in time after the engine turned over for the first time. N Slide control to START = starting throttle position N Set the choke lever to e = warm start, even if the engine is cold N Pull the starter rope through 10-20 times to ventilate the combustion chamber N Restart the engine If the tank has been drained completely N Refueling N Press the fuel pump bulb 7-10 times - even if it is full of fuel N Set the choke lever in accordance with the engine temperature N Restart the engine 370BA057 KN 370BA059 KN N Set choke lever (4) to f - press the button of the decompression valve and continue cranking 3 START N Slide control (3) toSTOP or 0 32 TS 410, TS 420