Stihl HT 132 Instruction Manual - Page 21

Mounting the Bike Handle A 4 1 English 7 6 8 7 5 9 4 9 0000-GXX-2034-A0 0000-GXX-0524-A0 0000-GXX-0525-A0 N Hold the lower clamp (1) and upper clamp (2) firmly together. N Release the clamp screw (3) - the clamps are loose once the clamp screw has been released. They are pushed apart by the two springs (4 and 5). N Pull out the clamp screw - the washer (6) remains on the clamp screw. N Separate the clamp moldings - the springs (4 and 5) remain in the lower clamp. N Place the handlebar (4) in the lower clamp (1) so that distance A is no more than 15 cm (6 in). N Place the upper clamp (2) in position and press it down. N Insert the clamp screw (3). N Line up the handlebar (4) at a right angle to the drive tube. N Tighten down the clamp screw (3) firmly. N Take out the screw (5), the nut (6) remains in the control handle (7). N Push the control handle onto the handlebar (4) until the holes (9) line up - the throttle trigger (8) must point towards the gearbox. N Insert the screw and tighten it down firmly. N Go to "Adjusting the Throttle Cable". Transport and storage position: Loosen the clamp screw, turn the handlebar in line with the drive tube and fold the handles down. FS 311 19