Sony STRDG1100 Operating Instructions - Page 35
: Preparing the receiver and the remote, Release the TONE MODE - reset
![]() |
UPC - 027242710931
View all Sony STRDG1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Getting Started 6: Preparing the receiver and the remote Connecting the AC power cord (mains lead) Connect the AC power cord (mains lead) to a wall outlet. Notes • Before connecting the AC power cord (mains lead), make sure that metallic wires of the speaker cords are not touching each other between the SPEAKERS terminals. • Connect the AC power cord (mains lead) firmly. Performing initial setup operations Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults. 1,2 2,3 2,3 To the wall outlet AC OUTLET Notes • The AC OUTLET(s) on the rear of the receiver is a switched outlet, which supplies power to the connected component only while the receiver is turned on. • Make sure that the total power consumption of the component(s) connected to the receiver's AC OUTLET(s) does not exceed the wattage stated on the rear panel. Do not connect high-wattage electrical home appliances such as electric irons, fans, or TVs to this outlet. This may cause a malfunction. 1 Press POWER to turn off the receiver. 2 Hold down POWER while pressing TONE MODE and DMPORT to turn on the receiver. 3 Release the TONE MODE and DMPORT after a few seconds. After "MEMORY CLEARING..." appears on the display for a while, "MEMORY CLEARED!" appears. All the settings you have changed or adjusted are reset to the initial settings. 35GB
![](/manual_guide/products/sony-strdg1100-operating-instructions-908b153/35.png)