Sony SNCWR602 User Manual (SNC-WR600-602-630-632 user guide) - Page 44

Administrating the Camera Sensor input 1: The external sensor that is connected to sensor input 1 of the camera I/O port. Sensor input 2: The external sensor that is connected to sensor input 2 of the camera I/O port. Sensor input 3: The external sensor that is connected to sensor input 3 of the camera I/O port. Sensor input 4: The external sensor that is connected to sensor input 4 of the camera I/O port. Camera tampering detection: The alarm is triggered if the camera detects tampering, such as direction shifting or spray. Motion detection: The alarm is triggered by the motion detection function. VMF: The alarm is triggered by the VMF function. Face detection: The alarm is triggered by the face detection function. Network disconnection: The alarm is triggered by disconnection to a specific IP address. Note You cannot set Camera tampering detection and Network disconnection in the same event condition. Interval Specify the interval time used when condition is set to and, then. In the case the condition is set as 1 and 2, the system sounds an alarm when either 1 or 2 happens, and the other happens within the specified interval. In the case the condition is set as 1 then 2, the system sounds an alarm when 1 happens, and then 2 happens within the specified interval. If you select "or" condition, this setting will be ignored. The maximum duration to be set is 7200 seconds. Sensor input Tab - Set the sensor input 1/2/3/4 Sensor input mode Set the direction of the detected input signal to the sensor input terminal of the camera. Normally open: Triggers an alarm when the sensor input is short-circuited. Normally closed: Triggers an alarm when the sensor input is open-circuited. Notes • Allow at least two seconds for the input signal to be detected; otherwise, some events may not be detected. • When you use video streaming by SSL connection, set as follows. Some events may not be detected if the camera is not in the following conditions. - Set the Bit rate below 1 Mbps. - Set the Frame rate below 30 fps. - Use the video streaming below two transmissions at the same time. OK/Cancel See "Buttons common to every menu" on page 20. Camera tampering detection Tab - Set the camera tampering detection Note Deselect the checkbox of Stabilizer in the Installation tab of the System menu. After setting the camera tampering detection, set the Stabilizer function again. Enable Select the checkbox to activate the function to detect camera tampering, such as direction shifting or spray. Detection status Display the tampering detection state of the time when Camera tampering detection tab is opened. To clear the detection status, click Clear button. OK/Cancel See "Buttons common to every menu" on page 20. Motion detection Tab - Set the motion/VMF detection Motion detection responds to moving objects in the camera image and triggers an alarm. In VMF, an alarm sounds when motion is detected under the motion detection setting, entering or passing through a specified area or inspection line. An alarm also sounds when an object has been left or removed from a specified area or inspection line. The detected object will be displayed on the monitor in the green frame. The removed object and left object will be displayed in the magenta frame. When you click the Motion detection tab, a dialog appears. Enter the user name and password. The factory setting of the user name and password for the Administrator is set to "admin". Change the password from the factory setting for the security of your devices. Note Perform the following before setting the motion detection. 44 Setting the Sensor input/Camera tampering detection/Motion detection - Action input Menu