Sharp XG-P610X XG-P610X Setup Manual - Page 41

Stack Projection

Get Sharp XG-P610X - XGA DLP Projector PDF manuals and user guides View all Sharp XG-P610X manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

Stack Projection The stack projection allows you to increase the brightness of an image by stacking two projectors and projecting same image simultaneously. Info • To set up the stack projection, assign a projector as the master and the other projector as the slave and connect the projectors with commercially available LAN cables (UTP cable, Category 5, cross-over type). In this way, you can control the both projectors with one remote control. • The buttons below can control both the master and the slave at one time. • ON button • VOLUME buttons • STANDBY button • AUTO SYNC button • SHUTTER button • RESIZE button • COMPUTER1/2, DVI, HDMI, • PICTURE MODE button VIDEO, S-VIDEO buttons • BREAK TIMER button • MUTE button • FREEZE button • In normal operation, the projector set as the slave cannot be controlled by the remote control. Only while the remote control is connected to the projector with a ø3.5 mm minijack cable (commercially available or available as Sharp service part QCNWGA038WJPZ), the projector set as the slave can be controlled by the remote control. • Even while the projector is set as the slave, the buttons on the projector can be used. -41

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
-41
Stack Projection
The stack projection allows you to increase the brightness of an image by stacking two
projectors and projecting same image simultaneously.
Info
•
To set up the stack projection, assign a projector as the master and the other projector as the slave and
connect the projectors with commercially available LAN cables (UTP cable, Category 5,
cross-o
v
er type).
In this way, you can control the both projectors with one remote control.
•
The buttons below can control both the master and the slave at one time.
• ON button
• VOLUME buttons
• STANDBY button
• AUTO SYNC button
• SHUTTER button
• RESIZE button
• COMPUTER1/2, DVI, HDMI,
• PICTURE MODE button
VIDEO, S-VIDEO buttons
• BREAK TIMER button
• MUTE button
• FREEZE button
•
In normal operation, the projector set as the slave cannot be controlled by the remote control.
Only while the remote control is connected to the projector with a ø3.5 mm minijack cable (commercially
available or available as Sharp service part QCNWGA038WJPZ), the projector set as the slave can be
controlled by the remote control.
•
Even while the projector is set as the slave, the buttons on the projector can be used.