Sharp PN-HB651 PN-HB Series PN-HM Series Operation Manual - Page 35

Menu Items nAbout remote control numbers If there is another monitor nearby, you can change the remote control number to prevent the other monitor from being operated by the remote control unit. Set the same number in the monitor and in the remote control unit. TIPS • You can set remote control numbers to values from 0 to 9. • When the remote control unit batteries become exhausted and when you replace the batteries, the number on the remote control unit may be reset to 0. Changing the remote control number on the monitor Use REMOTE No. on the SETUP menu to set the number. (See page 28.) 1. Use the or button to select the remote control number. 2. Select ON and press the ENTER button. The remote control number is set on the monitor. Changing the remote control number on the remote control unit 1. While holding down the ID SET button, hold down the number that corresponds to the remote control number set on the monitor for 5 seconds or more, and then release these buttons. The remote control number is set on the remote control unit. Checking the remote controller number 1. Press the INFORMATION button to display INFORMATION1. 2. Check that REMOTE No. is the remote control number that you have set in the above procedure. 3. Press the RETURN button to close the monitor INFORMATION screen. Adjustments for computer screen display nAutomatic adjustment When you use the D-SUB to display a computer screen for the first time, or when you change the setting of the computer, use the automatic screen adjustment. 1. Switch the input to D-SUB and display the adjustment pattern. (See the description below.) 2. Press the MENU button and use the or button to display the SCREEN menu. 3. Press the ENTER button and select "AUTO". 4. Press the ENTER button. The automatic adjustment is complete in several seconds. 5. Press the MENU button to close the menu screen. TIPS • If the screen cannot be adjusted properly with one automatic adjustment, repeat the automatic adjustment two or three times. Try manual adjustment if necessary. nScreen display for adjustment Before making adjustments in the SCREEN menu or PICTURE menu, display an image to brighten the entire screen. If you are using a Windows computer, use the adjustment pattern on the supplied CD-ROM. Opening the adjustment pattern The following example is performed in Windows 7. 1. Load the supplied CD-ROM into the computer's CD- ROM drive. 2. Open [CD Drive] in [Computer]. 3. Double-click [Adj_uty.exe]. The adjustment pattern will appear. Adjust the screen automatically or manually. TIPS • If the remote control numbers on the monitor and remote control unit are different, they will both be displayed on INFORMATION1. On this screen, you can press the ENTER button to match the number on the monitor with the number on the remote control unit. • Even if the remote control numbers are different, you can use the remote control unit to display the INFORMATION screen. 4. When adjustment is finished, press the [Esc] on the computer's keyboard to quit the adjustment program. 5. Eject the CD-ROM from the CD-ROM drive. TIPS • If the display mode on the computer you are using is 65000 colors, the color levels in the color pattern may appear differently or grayscale may appear to be colored. (This is due to the specifications of the input signal and is not a malfunction.) 35 E