Sanyo PLC-XU45 Owners Manual - Page 15

BEFORE OPERATION ZOOM BUTTON Used to adjust zoom. (P20) ON-OFF ZOOM FOCUS VOLUME LOCK FOCUS BUTTON Used to adjust focus. (P20) MUTE BUTTON Used to mute sound.(P21) MUTE D.ZOOM INPUT MENU KEYSTONE BUTTON Used to correct keystone distortion. (P20, 34) NO SHOW BUTTON Used to turn the picture into black image. (P21) AUTO PC ADJ. BUTTON Used to operate AUTO PC Adjustment function. (P23) LASER KEYSTONE NO SHOW FREEZE AUTO PC ADJ. IMAGE P-TIMER VOLUME BUTTON Used to adjust volume. (P21) D.ZOOM BUTTON Used to select DIGITAL ZOOM +/- mode and resize image. (P28) Operating Range Point the Remote Control toward projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for Remote Control is about 16.4' (5m) and 60° in front and rear of the projector. 16.4' (5 m) 60° FREEZE BUTTON Used to freeze the picture. (P20) IMAGE BUTTON Used to select image level. (P26, 31) 60° 16.4' (5 m) REMOTE CONTROL BATTERIES INSTALLATION 1 Remove the battery compartment lid. Press the lid downward and slide it. 2 Slide the batteries into the compartment. Two AA size batteries For correct polarity (+ and -), be sure the battery terminals are in contact with the pins in the compartment. 3 Replace the compartment lid. To insure safe operation, please observe the following precautions : G Use (2) AA, UM3 or R06 type alkaline batteries. G Replace two batteries at the same time. G Do not use a new battery with a used battery. G Avoid contact with water or liquid. G Do not expose the Remote Control to moisture, or heat. G Do not drop the Remote Control. G If a battery has leaked on Remote Control, carefully wipe case clean and install new batteries. G Risk of explosion if battery is replaced by an incorrect type. G Dispose of used batteries according to the instructions. 15