Sanyo PLC-WTC500L RS232C Basic - Page 9
Operation Requirements
View all Sanyo PLC-WTC500L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
PLC-WTC500L Basic Serial Command Functional Specifications 6.4 Operation Requirements 1) In the following status of projector, Available Functional Execution Commands are limited. Projector Status Standby Mode Countdown in process Available Functional Execution Commands C00: POWER ON C00: POWER ON Countdown is terminated C01: POWER OFF C02: POWER OFF Countdown is terminated C46: ZOOM C47: ZOOM + C4A: FOCUS C4B: FOCUS + C5D: LENS SHIFT UP C5E: LENS SHIFT DOWN C5F:LENS SHIFT LEFT C60:LENS SHIFT RIGHT Cooling Down in process Cooling Down due to Abnormal Temperature Abnormal Temperature Status When ZOOM+/-, FOCUS +/-, LENS SHIFTUP/ DOWN/LEFT/RIGHT are executed during Countdown is in process, POINTER Command become effective, and ZOOM/FOCUS/LENS SHIFT become enable to control by POINTER Command. (*POINTER Command:C3A/CA3B/C3C/C3D) NONE (No Execution) NONE (No Execution) NONE (No Execution) Abnormal Power Status NONE (No Execution) Abnormal Filter Status Power-Save Cooling Down in process Power Save Status Cooling Down in process after OFF operation due to Lamp Failure NONE (No Execution) NONE (No Execution) C00: POWER ON C01: POWER OFF NONE (No Execution) Note) in above status, the projector returns [ACK] [CR] even if it receives the other command. 2) When Standby mode of Setting menu is set to Eco and Projector status is in Standby mode, Functional execution commands are invalid 9/25