Samsung WF409ANW (English) - Page 16
setting up your new washing machine
View all Samsung WF409ANW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
setting up your washer 3. Check the inlet hose to ensure a washer is inside each fill hose. Cold Thread the inlet hoses to the HOT and COLD faucet connections. On the other end of the hose, check for one rubber washer per hose and install each fill hose to the water valve. Make sure the hose with the Hot printed line is attached to the HOT faucet. Tighten by hand until snug, then two-thirds of a turn with pliers. For correct water use, connect both HOT and COLD water valves. If either or both are not connected, an "nF" (no fill) error can occur. 4. Turn on the HOT and COLD water supply and check all connections at the water valve and the faucet for leaks. Cold printed Hot Hot printed 5. Plug the power cord into a 3-prong, well grounded 120 volt 60 Hz approved electrical outlet protected by a 15-amp fuse or comparable circuit breaker. Your washer is grounded through the third prong of the power cord when plugged into a three-prong grounded receptacle. 6. Slide your washer into position. 7. Level your washer by turning the leveling legs in or out as necessary by hand or by using the wrench included with your washer. When your washer is level, tighten the locking nuts using the wrench or (-) flathead screwdriver. Your washer must be leveled on all four sides. A carpenter's level should be used on all four corners of your washer. It's the best to recheck after the first dozen washes. Locking Nut Avoid damage to the legs. Do not move the washer unless the locking-nuts are fastened to the bottom of the washer. Levelling Leg 16_ setting up your new washing machine WF409ANW-02657D-02_EN.indd 16 2009-12-04 ¿ÀÀü 11:19:41