Samsung NZ30M9880UB Installation Guide - Page 10

Installation instructions 3-Wire Cable from Power Supply to 3-Wire Cable from Cooktop IMPORTANT: where local codes permit, 3-wire cable can be use to supply power. In those cases connect connect cooktop ground wire to the neutral wire from the junction box. 1. Disconnect power. A E 2. Remove Junction box cover, if present. B 3. Connect the flexible cable condult from F the cooktop to the junction box using G a UL listed or CSA approved condult H connector. C 4. Tighten screws on condult connector, if D I present. 5. Connect the two L2 wires together using the UL listed wire connectors. A. 3-wire cable from power 6. Connect the two L1 wires together using supply the UL listed wire connectors. B. L1 wires 7. Connect the Ground (G) or bare ground C. Ground (G) or bare ground wire from the cooktop cable to the wire (from cooktop) Ground (G) or bare ground wire (in the D. 3-wire cable from cooktop junction box) using a UL listed wire E. Junction box connectors. F. N (normally White) wire (from 8. Install junction box cover. power supply) 9. Reconnect power. G. UL listed wire connector H. L2 (normally Red) wires I. UL listed or CSA approved conduit connector Complete installation 1. Check that all parts are now installed. If there is an extra parts go back through the steps to see if any steps were skipped.. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Use a mild solution or liquid household cleaner and warm water to clean cooktop before use. Dry throughly with a soft cloth. For more information, see the User's Manual. 5. Reconnect power. If You Need Assistance or Service: Please reference the "User Manual" or contact the dealer from whom cooktop was purchased. Installation instructions 10 English CHEF-INDU_NZ30M9880_NZ36M9880_DG68-00827B-01_EN+MES+CFR.indb 10 5/25/2018 7:07:52 PM