Pyle PTCDCS3UIP PTCDCS3UIP Manual 1 - Page 8

Big Horn Speaker Assembly Instructions

Page 8 highlights

BIG HORN SPEAKER ASSEMBLY INSTRUCTIONS 1.) Look at picture Fig1. According to the correct position, put the big horn speaker(A) into the middle tube(C). Please note to line up the hole on the speaker with the slot on the tube. Be careful that your hand is not inured by the big horn speaker. 2.) Look at Fig2. Fig3. Rotate two screws A (E) clockwise into the hole. Tighten clockwise with a Philip's head screwdriver. 3.) Look at Fig4.It shows the assembled big horn speaker apparatus Fig1 Fig2 Fig3 Fig4 4.) Look at Fig5. Put the PTCDCS3UIP host cabinet flat on the table. Line the holes on the bottom tube(D) up as shown with the holes on the cabinet so that the open end of the tubing face upwards. Rotate three screws C(G) clockwise into the holes.Tighten with a Philip s head screwdriver. 5.) Look at Fig6. It shows the assermbled PTCDCS3UIP host cabinet apparatus. Fig5 Fig6 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18

7
BIG HORN SPEAKER ASSEMBLY INSTRUCTIONS
1.)
Look at picture Fig1. According to the correct position, put the big horn
speaker(A) into the middle tube(C). Please note to line up the hole on the
speaker with the slot on the tube. Be careful that your hand is not inured by
the big horn speaker.
2.)
Look at Fig2. Fig3. Rotate two screws A (E) clockwise into the hole. Tighten
clockwise with a Philip's head screwdriver.
3.)
Look at Fig4.It shows the assembled big horn speaker apparatus
Fig1
Fig2
Fig3
Fig4
4.)
Look at Fig5. Put the
host cabinet flat on the table. Line the
holes on the bottom tube(D) up as shown with the holes on the cabinet so
that the open end of the tubing face upwards. Rotate three screws C(G)
clockwise into the holes.Tighten with a Philip s head screwdriver.
5.)
Look at Fig6. It shows the assermbled PTCDCS3UIP host cabinet
apparatus.
PTCDCS3UIP
Fig5
Fig6