Pyle PSKIW25BK PSKIW25GN Manual 1 - Page 14

13.8 Calibrating Mode - Calibration the Compass Compass Mode Hold [M] Hold [M] [M] Rotation Calibration Display Magnetic Declination Display Compass Calibration When to Calibrating the Compass ! The Watch has to employ a compass calibration in one of the following conditions: 1) The Watch is using for the first time, 2) The battery has been replaced, 3) The bearing direction digits are flashing, and the "OFF CAL" indicator appear, 4) The compass use in a location that is apart from the place in which the compass had been calibrated, 5) The user intends to regulate the precision of the digital compass. How to Calibrate the Compass ! The compass calibration includes two different processes: Rotation Calibration Mode and Magnetic Declination Setting. ! It is advisable to carry out them both from time to time, that achieves a more accurate reading. IMPORTANT: If the Watch has not been calibrated, the direction made by the Watch may be a inaccurate direction. 13.9 Calibrating the Compass - Compass Rotation Calibration Mode Compass Mode Hold [M] Hold [M] [M] Rotation Calibration Display ! To select the Rotation Calibration Display, hold the [M] button in Compass Mode. ! To start rotation calibration, press [S/S] button once. The pointers will start rotating, turning the watch (keep parallel to the horizon) in the same direction of the rotating pointers for more than 2 turns. ! Press [S/S] or [L/R] button to stop the calibration when the 2-turn rotation calibration is completed. ! When the pointer stop rotating, hold the [M] button to go back to the Compass Mode or press the [M] button once to set the magnetic declination. Rotation Calibration Stop Display [S/S] [S/S] / [L/R] Magnetic Declination Display pointers rotated at 15 seconds per round Rotation Calibration Turning Display Compass Calibration 13.10 Calibrating the compass - Magnetic Declination Mode Compass Mode Hold [M] Hold [M] SE T [M] Magnetic Declination Mode ! Check the previous section "Magnetic Declination at Major Cities" to get the magnetic declination of the city which is close to your current position. That value will be input into the Watch during the calibration. ! To select Magnetic Declination Display, press the [M] button in Rotation Calibration Display. ! When the current magnetic declination appears, press the [S/S] or [L/R] button to increase / decrease the number. (Hold down the button to change the number at a higher speed). ! If the setting is completed, hold the [M] button to confirm the setting and exit the adjustment display. Rotation Calibration Stop Display Magnetic Declination Display hold [S/S]/[L/R] [S/S]/[L/R] Increase / Decrease the number Compass Calibration Increase / Decrease the number at a higher speed Magnetic Declination Display 14.0 Battery - Battery Low Indication and Battery Replacement Batte ry -Low In dic ato r Battery Low Detection ! When the battery-low indicator appears on the display, it means that the capacity of the battery is low. It is recommended to replace the battery with a new CR2032 battery. ! However, if the appearance of the battery-low indicator is caused by using the Watch under very cold condition, the indicator will disappear when normal temperature returns. NOTE: It is recommended to complete the battery replacement by a certified service agency because this Watch contains delicate electronic sensors and components. IMPORTANT: If the battery is replaced, all memory will be cleared. Follow the previous chapter "Calibrating the Compass" to calibrate the compass before using the Compass.