Philips 34E1C5600HE User manual - Page 16

2. Toggle to the up or down to select main menu [PIP / PBP], then toggle to the right to confirm. 3. Toggle to the up or down to select [PIP / PBP Mode], then toggle to the right. 4. Toggle to the up or down to select [PIP], [PBP], then toggle to the right to confirm your selection. 5. Now you can move backward to set the [PIP / PBP Input], [PIP Size], [PIP Position] or [Swap]. Toggle to the right to confirm your selection. MultiView in OSD menu • PIP / PBP Mode: There are two modes for MultiView: [PIP] and [PBP]. [PIP]: Picture in Picture Open up a sub-window of another signal source. B A (main) When the sub source is not detected: B A (main) [PBP]: Picture by Picture Open up a sub-window side-by-side of other signal sources. A B (main) When the sub source is not detected. A (main) Note The black strip shows on the top and the bottom of the screen for the correct aspect ratio when in the PBP mode. If you expect to see full screen side by side, adjust your devices resolutions as pop up attention resolution, you will able to see 2 devices source screen project to this display side by side without black strips. Note the analog signal is not support this full screen in PBP mode. • PIP / PBP Input: There are different video input to choose as the sub display source: [HDMI 2.0], [DisplayPort],and [USB C]. Please refer below table for compatibility of main/sub input source. SUB SOURCE POSSIBILITY (xl) Inputs HDMI DisplayPort USB C MAIN HDMI ● ● ● SOURCE DisplayPort ● ● ● (xl) USB C ● ● ● • PIP Size: When PIP is activated, there are three sub-window sizes to choose: [Small], [Middle], [Large]. BSmall Middle A Large (main) • PIP Position: When PIP is activated, there are four sub-window positions to choose. Top-Left B A (main) Top-Right B A (main) 14