Panasonic SC-UA3 Owners Manual - Page 11
Clock and timers
View all Panasonic SC-UA3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH █ Selecting a preset station 1 Press [PLAY MENU] repeatedly to select "TUNE MODE". 2 Press [R, T] to select "PRESET" and then press [OK]. 3 Press [2/3] or [5/6] to select the preset station. Using the unit 1 Press [8] to select "PRESET". 2 Press [2/3] or [5/6] to select the preset station. Improving the sound quality 1 Press [PLAY MENU] repeatedly to select "FM MODE". 2 Press [R, T] to select "MONO" and then press [OK]. To cancel, select "STEREO". "MONO" is also cancelled when you change the frequency. To memorise the setting Continue with step 4 of "Manual presetting". (Z page 10) Checking the signal status Press [DISPLAY] to select "FM STATUS". FM - - - - FM ST FM MONO The FM signal is weak. The system is not tuned in to a station. The FM signal is in stereo. "MONO" is selected as the "FM MODE". The FM signal is in monaural. RDS broadcasting This system can show the text data transmitted by the radio data system (RDS) available in some areas. Press [DISPLAY] repeatedly. PS PTY FREQ Programme service Programme type Frequency Note: RDS may not be available if reception is poor. Clock and timers Setting the clock This is a 24-hour clock. 1 Press [SETUP] repeatedly to select "CLOCK". 2 Press [R, T] to set the time and then press [OK]. To check the time Press [SETUP] repeatedly to select "CLOCK" and then press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Play timer (Except for Bluetooth®, AUX and D-IN source) You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] repeatedly to select "TIMER ADJ". 2 Press [R, T] to set the start time and then press [OK]. 3 Do step 2 again to set the end time. 4 Press [R, T] to select the source you want to play and then press [OK]. To start the timer 1 Prepare the source you want to listen to (disc, USB or radio) and set the volume. 2 Press [SETUP] repeatedly to select "TIMER SET". 3 Press [R, T] to select "PLAY ON" and then press [OK]. "#" is shown. To cancel, select "PLAY OFF". The system must be switched off for the timer to operate. To check the setting Press [SETUP] repeatedly to select "TIMER ADJ" and then press [OK]. In standby mode, press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. • The timer comes on at the set time every day if the timer is on. • If you switch off the system and then switch on again while a timer is in operation, the timer will not stop at the end time. TQBJ2015 11 11