Oki ES9465 ES9465/ES9475 Copying Guide - Page 44

2 HOW TO MAKE COPIES The operating procedure for copying from MPT differs depending on the paper size to be used. See the table below for the operating procedure of each size. Paper size Standard size Other than North America: A3, A4, B4, B5 North America: LD, LT, LG, ST-R Other than the above Envelope Others (Non-standard sizes) Procedure P.42 "Copying on A3, A4, B4 and B5 size paper (in equipment other than for North America) / LD, LT, LG and ST-R size paper (in equipment for North America)" P.46 "Copying on other than the above standard sizes of paper" P.49 "Copying on an envelope" P.52 "Copying from MPT on non-standard size paper" y Copying from MPT stops when the paper placed on the MPT runs out during copying, even if the paper of the same size is in any of the trays. Copying restarts when paper is supplied to the MPT. y When copying from MPT has been completed, the [RESET] button on the control panel blinks. Press this button to switch Copying from MPT to normal copying using the trays. (Even if you do not press the [RESET] button, the Copying from MPT mode will be cleared when the automatic function clear mode kicks in after a specified period of time.) „ Copying from MPT on standard size paper ‰ Copying on A3, A4, B4 and B5 size paper (in equipment other than for North America) / LD, LT, LG and ST-R size paper (in equipment for North America) 1 Place the original(s). 2 Move the paper holding lever toward the outside. Place paper with its copy side down on the MPT. 1 2 y The height of the paper must not exceed the indicator on the side guides. y When you use more than one sheet of paper, fan the sheets well before placing them on the MPT. Be careful not to cut your fingers when fanning. y Do not push paper into the entrance of the MPT. This could cause a paper misfeed. 3 Align the side guides to the paper length. Move the paper holding lever toward the equipment. When paper is placed, the menu for copying from MPT appears. 42 Copying from MPT