Netgear M4300-28G Software Setup Manual Software Version 12.x - Page 15
Do you want to set new Management VLAN ID Y/N/Q?, C - Change IPv4 address. - default password
View all Netgear M4300-28G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Admin password not defined. Do you want to assign the admin password (password length should vary in a range of 8 - 64 characters)? (Y/N/Q) You are prompted to change the admin password. 4. For security reasons, change the default password by typing Y, typing a new password, and confirming the password. If you already set the password and do not want to change it again, type N. Enter new password:******** Confirm new password:******** Password Changed! The 'enable' password required for switch configuration through the command line interface is currently not configured. Do you wish to change it (Y/N/Q)? y Enter new password:******** Confirm new password:******** Password Changed! 5. To change the management VLAN ID, type Y, and type a new VLAN ID. Current Management VLAN ID: 1 Do you want to set new Management VLAN ID (Y/N/Q)? You are prompted to set up the IP address of the switch. 6. Set up the IP address of the switch, either manually (type C) or through DHCP (type D): Assigning an IPv4 address to your switch management Current IPv4 Address Configuration Management VLAN ID: 1 IPv4 Address Assignment Mode: Manual IPv4 Address: 0.0.0.0 Subnet Mask: 0.0.0.0 Default Router IPv4: 0.0.0.0 Routing Mode: Enable IPv4 address has been assigned manually. What do you want to do? C - Change IPv4 address. D - Assign IPv4 address for the switch using DHCP Mode(current IPv4 address will be lost). Get Started 15 Software Setup Manual