NEC NP-PA1004UL-B User Manual - Page 165
Hints on How to Set Up LAN Connection, NETWORK SETTINGS]
![]() |
View all NEC NP-PA1004UL-B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
[NETWORK SETTINGS] 5. Using On-Screen Menu Configure the various settings when using the projector connected to a network. Important: • Consult with your network administrator about these settings. • When using a wired LAN, connect the Ethernet cable (LAN cable) to the LAN port on the projector. (→ page 168) • Please use a shielded twisted pair (STP) cable of Category 5e or higher for the LAN cable (sold commercially). • The default [WIRED LAN] setting of this projector is set to [DISABLE] when it is shipped from the factory. To connect to a network, change the [WIRED LAN] profile setting from [DISABLE] to [PROFILE 1] or [PROFILE 2] to enable the wired LAN. TIP: • The network settings you make will not be affected even when [RESET] is done from the menu. Hints on How to Set Up LAN Connection To set up the projector for a LAN connection: Select [WIRED LAN] → [PROFILES] → [PROFILE 1] or [PROFILE 2]. Two settings can be set for wired LAN. Next turn on or off for [DHCP], [IP ADDRESS], [SUBNET MASK], and [GATEWAY] and select [OK] and press the ENTER button. (→ page 143) To recall LAN settings stored in the profile number: Select [PROFILE 1] or [PROFILE 2] for wired LAN, and then select [OK] and press the ENTER button. (→ page 143) To connect a DHCP server: Turn on [DHCP] for wired LAN. Select [ON] and press the ENTER button. To specify IP address without using the DHCP server, turn off [DHCP]. (→ page 143) To receive error messages via e-mail: Select [ALERT MAIL], and set [SENDER'S ADDRESS], [SMTP SERVER NAME], and [RECIPIENT'S ADDRESS]. Last, select [OK] and press the ENTER button. (→ page 145) 141
![](/manual_guide/products/nec-nppa1004ulb-user-manual-49a2159/165.png)