Maytag MFD2561HE Use and Care Guide - Page 13
Fresh, FoodFemures - manuals
View all Maytag MFD2561HE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
FresFhoodFemures ii Shelves Your refrigerator has Spill-Catcher"* Glass Shelves. The shelves have a spill retainer edge which allows for easier clean up and some are equipped with a slide out feature. To slide out, grasp the front of the shelf and pull forward. Push in the shelf to return to the original position. To Remove a Shelf: • Slightly tilt up the front and lift up the rear of the shelf, then pull the shelf straight out. To Lock the Shelf Into Another Position: • Tilt up the front edge of the shelf. • Insert the hook into the desired frame openings and let the shelf settle into place. • Be sure the shelf is securely locked at the rear. To Remove Elevator TM Shelf: • Completely unload the shelf and pull the shelf forward. • Pull until the shelf stops. • Press up on the tabs located underneath its outside edges and continue pulling forward until the shelf is clear of the frame. To Replace Elevator TM Shelf: • Align the shelf to the frame and push it all the way back It is not necessary to press up on the tabs for reinstallation. in ordinary use, the Elevator TM Shelf frame assembly does NOT require removal. Though unlikely, and not recommended, the correct removal procedure is as follows: To Remove Frame Assembly; • Unload the shelf completely. • Slide the shelf forward about 2" and manually move the two rear latches toward the shelf center. •While supporting the entire shelf and frame from underneath, lift slightly and rotate the assembly approximately 30 ° to allow the rear mechanism to clear the vertical rear side rails. • The entire assembly can then be moved forward and clear of the refrigerator compartment. To Reinstall Frame Assembly: • Reverse the removal procedure. Be sure the shelf is in a level position. When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct operating position. Elevator" Shelf (select models) The Elevator TM Shelf is equipped with a spilt-retaining edge and the EasyGlide TM slide-out feature. It can be adjusted up or down without unloading. To Slide Out Elevator" Shelf:. • Grasp the front of the shelf and pul! forward. • Push the shelf in to return to odginal position. To Adjust the Elevator" Shelf: • Pull out the knob on the crank handle. • Rotate the crank clockwise to raise the shelf, and counterclockwise to lower the height of the shelf. Cstyle may vary) FrameAssembly Slide Out Shelf