Marantz SR8015 Sound Mode Table - Page 2

Before Servicing This Unit Electrical Sound mode table Sound modes and channel output ○ This indicates the audio output channels or surround parameters that can be set. ◎ This indicates the audio output channels. The output channels depend on the settings of "Speaker Config.". Channel output Sound mode Front L/R Center Surround L/R Surround Back L/R Front Wide Front Height Top Front Top Middle L/R L/R L/R L/R Top Rear L/R Rear Height L/R Surround Height L/R Center Height Top Surround Front Surround Back Dolby Atmos Dolby Atmos Dolby Atmos Enabled Enabled Enabled L/R L/R L/R Subwoofer Direct/Pure Direct (2-channel) Direct/Pure Direct (Multi-channel) DSD Direct (2-channel) DSD Direct (Multi-channel) Stereo ○ ◎※ 5 ○ ◎ ◎ ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎※ 6 ◎ ○ ◎※ 5 ○ ◎ ◎ ◎ ○ ◎ Dolby Atmos ○ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ Dolby TrueHD ○ ◎ ◎ ◎※ 6 ◎ Dolby Digital Plus ○ ◎ ◎ ◎※ 6 ◎ Dolby Digital ○ ◎ ◎ ◎ Dolby Surround ※ 1 ○ ◎ ◎ ◎※ 7 ◎※ 8 ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ IMAX DTS:X ※ 2 ○ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ IMAX DTS ○ ◎ ◎※ 9 ◎※ 9 ◎ DTS:X ※ 2 ○ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ DTS-HD ○ ◎ ◎ ◎※ 6 ◎※ 6 ◎ DTS Express ○ ◎ ◎ ◎ ◎ DTS 96/24 ○ ◎ ◎ ◎ ◎ DTS Surround ○ ◎ ◎ ◎ ◎ DTS Neural:X ※ 3 ○ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ ◎ DTS Virtual:X ※ 4 ○ ◎ ◎ ◎ ◎ Auro-3D ○ ◎ ◎ ◎ ◎ ◎※ 10 ◎ ◎ ◎ ◎※ 11 ◎※ 11 ◎※ 11 ◎ Auro-2D Surround ○ ◎ ◎ ◎ ◎ Multi Ch In ○ ◎ ◎ ◎※ 6 ◎ MPEG-2 AAC (JAPAN Model Only) ○ ◎ ◎ ◎ MPEG-4 AAC (JAPAN Model Only) ○ ◎ ◎ ◎ Multi Ch Stereo ○ ◎ ◎ ◎ ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎※ 12 ◎ Virtual ○ ◎ ※ 1 The applicable sound mode includes "Dolby Surround" and sound modes that have "+Dolby Surround" in the sound mode name. ※ 2 Audio can be played through a maximum of 11-channels when 11 speakers or more (excluding the subwoofer) are installed. ※ 3 The applicable sound mode includes "DTS Neural:X" and sound modes that have "+Neural:X" in the sound mode name. ※ 4 The applicable sound mode includes "DTS Virtual:X" and sound modes that have "+Virtual:X" in the sound mode name. ※ 5 Audio is output when "Subwoofer Mode" in the menu is set to "LFE+Main". ※ 6 A signal for each channel contained in an input signal is output as audio. ※ 7 Audio is not output when the "Speaker Virtualizer" in the menu is set to "On" and "Speaker Config." - "Surr. Back" in the menu is set to "1 spkr". ※ 8 Audio is not output when the "Speaker Virtualizer" is set to "On". ※ 9 W hen "Speaker Config." - "Surr. Back" is set to "2 spkrs", "Speaker Config." - "Center" is set to "Large" or "Small", and sound mode is set to "IMAX DTS", surround audio is output from the surround back speaker. Audio is not output from the surround speaker. ※ 10 For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in place of Surround Height speakers. ※ 11 For the best Auro-3D experience Front Height and Surround Height speakers are recommended, however you may substitute Dolby Atmos Enabled speakers. ※ 12 Audio is output from the speakers specified in the "Surround Parameter" - "Speaker Select" settings. Mechanical Repair Information Updating 7