Marantz SR6014 Owners Manual - Page 258
XT32, Audyssey Dynamic EQ
View all Marantz SR6014 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 258 highlights
Contents Connections Playback Settings Tips Appendix Audyssey MultEQ® XT32, Audyssey Dynamic EQ®, Audyssey Dynamic Volume® and Audyssey LFC™ cannot be selected. 0 These cannot be selected when you have not performed Audyssey® Setup. (v p. 198) 0 Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 132) 0 These cannot be selected when sound mode is "DTS Virtual:X" or sound mode that have "+Virtual:X" in the sound mode name. 0 Audyssey Dynamic EQ®, Audyssey Dynamic Volume® and Audyssey LFC™ cannot be selected when sound mode is "IMAX DTS:X" or "IMAX DTS". 0 These cannot be selected when using the headphones. "M-DAX" cannot be selected. 0 Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used. (v p. 172) 0 Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 132) No audio is output from PRE OUT or speakers for ZONE2. 0 In ZONE2, the audio can be played back when signals input from digital connectors (OPTICAL/COAXIAL) are in 2ch PCM format. 0 In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM format. To play back the audio in ZONE2 irrespective of the input signal format, set "HDMI Audio" in the menu to "PCM". Depending on the played back device, the audio may not be played back even with this setting. In that case, set the audio format to "PCM (2ch)" on the played back device. (v p. 238) 0 When listening to audio from a Bluetooth device in ZONE2, remove any obstructions between the Bluetooth device and this unit and use it within a range of about 98.4 ft/30 m. Front panel Display Rear panel 258 Remote Index