Marantz SR5012 Owner s Manual In English - SR5012 - Page 225

Contents Connections Playback Settings Tips Appendix Desired sound does not come out The volume does not increase. 0 The maximum volume is set too low. Set the maximum volume using "Limit" on the menu. (v p. 153) 0 Appropriate volume correction processing is performed according to the input audio format and settings, so the volume may not reach the upper limit. No sound comes out with the HDMI connection. 0 Check the connection of the HDMI connectors. (v p. 53) 0 When outputting HDMI audio from the speakers, set "HDMI Audio Out" on the menu to "AVR". To output from the TV, set "TV". (v p. 160) 0 When using the HDMI Control function, check that the audio output is set to the AV amplifier on the TV. (v p. 127) No sound comes out of a specific speaker. 0 Check that speaker cables are properly connected. 0 Check that a selection other than "None" is set for the "Speaker Config." setting in menu. (v p. 187) 0 Check the "Assign Mode" setting in the menu. (v p. 186) 0 When the sound mode is "Stereo" and "Virtual", audio is only output from the front speakers and subwoofer. No sound is produced from subwoofer. 0 Check the subwoofer connections. 0 Turn on the subwoofer's power. 0 Set "Speaker Config." - "Subwoofer" on the menu to "Yes". (v p. 188) 0 When "Speaker Config." - "Front" in the menu is set to "Large", depending on the input signal and the sound mode, no sound may be output from the subwoofer. (v p. 188) 0 When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the subwoofer. (v p. 195) 0 You can make the subwoofer always output sound by setting the "Subwoofer Mode" to "LFE+Main". (v p. 195) Front panel Display Rear panel 225 Remote Index