Marantz SR4320 SR4320 User Manual - Page 12
Connections
View all Marantz SR4320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
ENGLISH CONNECTIONS CONNECTING SPEAKERS System B Right Left GND ANTENNA AM GND FM (75 Ω) DSS IN DVD IN VIDEO VCR IN OUT REMOTE CONTROL MONITOR OUT IN OUT PHONO IN CD IN L CDR / MD IN OUT TAPE IN OUT DSS IN DVD IN VCR IN OUT PRE OUT MAIN IN R AUDIO AC OUTLETS 120V 60Hz UNSWITCHED 120W 1A MAX SWITCHED 120W 1A MAX SPEAKER SYSTEMS SYSTEM A : MINIMUM 8 OHMS SYSTEM B : MINIMUM 8 OHMS SYSTEM B R L R L SYSTEM A SERIAL NO. Connecting speaker wire 1 Strip away approx. 3/8 inch (10 mm) of wire insulation. 10 mm 2 Twist the exposed wire ends very tight to prevent short circuits. Right Left System A Connecting banana plug Banana plug connections are also possible. Tighten the knob by turning clockwise and then insert the banana plug. Banana plug 3 Loosen the knob by turning counterclockwise. 4 Insert one bare wire into the hole in the side of each terminal. CAUTION • Be sure to use speakers with the specified impedance shown on the rear panel of this unit. • To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. • Do not touch the speaker terminals when the power is on. It may cause electric shocks. • Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit. Note: Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, signal phase will be reversed and the sound quality will be corrupted. 5 Tighten the knob by turning clockwise to secure the wire. 7