Marantz M-CR611 Owners Manual English - Page 130
Cannot connect by Wi-Fi
View all Marantz M-CR611 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Contents Connections Playback Settings Tips Appendix o Cannot connect by Wi-Fi Symptom Cause / Solution Cannot connect to the network. 0 The network name and password (WEP, etc.) settings are wrong. Configure the network settings according to the setting details of this unit. 0 Reduce the distance between the wireless LAN access point and this unit, remove any obstructions and make sure the view to the access point is unobstructed before trying to connect again. Also, install microwave ovens and other network access points as far away as possible. 0 Check the router power supply. 0 This unit supports IEEE802.11.b/g/n. 0 Configure the access point channel settings away from channels that are being used by other networks. 0 This unit is not compatible with WEP (TSN). Cannot connect to WPS. 0 Check that the WPS mode of the router is operating. 0 Press and hold the Wi-Fi CONNECT button (WPS) on this unit for approx. 3 seconds within 2 minutes of operating the router. 0 A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption time to "None", "WPA-PSK (AES)" or "WPA2-PSK (AES)". 0 If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by using the Wi-Fi CONNECT/WPS button. In this case, use the "Auto-Scan" or "Manual" method to connect. Cannot connect to the 0 Update the iPhone/iPod touch/iPad firmware to the latest version. network using iPhone/iPod 0 When using a USB cable to configure the settings, the iOS device firmware version needs to support iOS touch/iPad. 5 or later. When configuring the settings via a wireless connection, iOS 7 or later needs to be supported. Page 114 - 109 114 - - Front/Top panel Rear panel Remote control 130 unit Index