LiftMaster CSW200501U CSW200501U Setup and Operation Manual - Page 13

EXPANSION BOARD TERMINALS EYE ONLY and COM EYE/EDGE and COM OPEN CLOSE T EYE/EDGE TERMINALS FUNCTIONALITY WIRING EXAMPLE Open or Close Direction Photoelectric Sensors, the functionality is based on the switch settings (located next to the terminals) Switch set to CLOSE: gate reverses fully when it hits obstruction Switch set to OPEN: gate reverses 4 seconds when it hits obstruction 1 EYE ONLY 2 EYE/ EDGE 3 EYE/ EDGE COM SBC Open or Close Direction Photoelectric Sensors or Edge Sensor, the functionality is based on the switch settings (located next to the terminals) Switch set to CLOSE: gate reverses fully when it hits obstruction Switch set to OPEN: gate reverses 4 seconds when it hits obstruction 1 EYE ONLY 2 EYE/ EDGE 3 EYE/ EDGE COM SBC OPEN CLOSE T EYE/EDGE and COM Open or Close Direction Photoelectric Sensors or Edge Sensor, the functionality is based on the switch settings (located next to the terminals) Switch set to CLOSE: gate reverses fully when it hits obstruction Switch set to OPEN: gate reverses 4 seconds when it hits obstruction OPEN CLOSE 1 EYE ONLY 2 EYE/ EDGE 3 EYE/ EDGE COM SBC TERMINALS SBC and COM OPEN and COM CLOSE and COM STOP and COM CONTROL STATION TERMINALS FUNCTIONALITY WIRING EXAMPLE O CLOSE • Gate command sequence - Open, Stop, Close, Stop, ... COM • Soft Open ,Soft Close, Soft Stop (maintained switch does not override external safeties and does not reset alarm condition) SBC OPN • Open command - opens a closed gate CLS • Soft open (maintained switch does not override external safeties and STP does not reset alarm condition) COM • If maintained, pauses Timer-to-Close at OPEN limit • Opens a closing gate and holds open an open gate • Close command - closes an open gate • Soft close (maintained switch does not override external safeties and does not reset alarm condition) • Stop command - stops a moving gate • Hard stop (maintained switch overrides Open and Close commands and resets alarm condition) • If maintained, pauses Timer-to-Close at OPEN limit • Overrides an Open or Close command 12