LiftMaster 8550WLB Owners Manual - Page 39

Operation Remote Control Your remote control has been programmed at the factory to operate with your garage door opener. Up to 12 Security+ 2.0 remote controls can be programmed to the garage door opener. Older LiftMaster remote controls are NOT compatible, see page 44 for compatible accessories. To program additional accessories refer to the instructions provided with the accessory or visit LiftMaster.com. If your vehicle is equipped with a Homelink®, you may require an external adapter depending on the make, model, and year of your vehicle. Visit www.homelink.com for additional information. TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/KEYLESS ENTRY PIN USING THE DOOR CONTROL 1. Press the navigation button below "MENU" to view the Features menu. 2. Use the navigation buttons to scroll to "PROGRAM". 3. Select "REMOTE" or "KEYPAD" to program from the program menu. 4. Remote Control: Press the button on the remote control that you wish to operate your garage door. Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. Repeat the steps above for programming additional remote controls or keyless entry devices. If programming is unsuccessful, program the remote using the learn button. 1 2 Press to continue. 3 Press to continue. TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL USING THE LEARN BUTTON 1. Press and release the LEARN Button on the garage door opener. 2. Press and hold the button on the remote control that you wish to use. Release the button when the garage door opener lights blink or two clicks are heard. 1 2 "cli"cckl"ick" LEARN Button LEARN LED To Erase the Memory ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES 1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you wish to use. ERASE ALL DEVICES (INCLUDING myQ® ENABLED ACCESSORIES) 1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6 seconds). 2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now erased. Reprogram any accessory you wish to use. ERASE THE Wi-Fi NETWORK FROM THE GARAGE DOOR OPENER 1. Press and hold the black adjustment button on the garage door opener until 3 beeps are heard (Approximately 6 seconds). 4 LEARN Button OR ???? PIN Black Adjustment Button ERASE THE CAMERA SETTINGS 1. Press and hold the reset button on the side of the camera for 10 seconds. The LED light will turn off, then flash red. You will need to set up your camera again after resetting it. Reset Button 39