LiftMaster 8550WLB Owners Manual - Page 19
Connect the Door Arm to the Trolley, IMPORTANT
View all LiftMaster 8550WLB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation 9 Connect the Door Arm to the Trolley IMPORTANT: The groove on the straight door arm MUST face away from the curved door arm. 1. Close the door. Disconnect the trolley by pulling the emergency release handle. Slide the outer trolley back (away from the door) about 2" (5 cm). 2. Attach the straight door arm to the outer trolley using the clevis pin. Attach with the ring fastener. 3. Attach the curved door arm to the door bracket using the clevis pin. Attach with the ring fastener. 4. Align the straight door arm with the curved door arm. Select two aligned holes (as far apart as possible) and attach using the bolts, nuts and lock washers. NOTE: If the holes do not line up, reverse the straight door arm. Select two aligned holes (as far apart as possible) and attach using the bolts, nuts and lock washers. 5. Pull the emergency release handle toward the garage door opener until the trolley release arm is horizontal. The trolley will re-engage automatically when the garage door opener is activated. HARDWARE Hex Bolt 5/16"-18 x 7/8" Lock Washer 5/16" Clevis Pin 5/16" x 1-1/4" Nut 5/16"-18 Ring Fastener Clevis Pin 5/16" x 1" CORRECT Straight Door Arm (Groove facing out) INCORRECT Curved Door Arm Straight Door Arm Curved Door Arm Ring Fastener Nut 5/16"-18 Lock Washer 5/16" Clevis Pin 5/16" x 1" Hex Bolt 5/16"-18 x 7/8" Clevis Pin 5/16" x 1-1/4" 19