Kyocera FS-9130DN FS-9130DN/9530DN Operation Guide (Advanced) Rev-1.1 - Page 76
Setting the Character Pitch for Courier/Letter Gothic, Setting the character code set, >Font Select
![]() |
View all Kyocera FS-9130DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Using the Operation Panel Setting the Character Pitch for Courier/Letter Gothic You can set the character pitch for fixed-pitch fonts when the default font is Courier or Letter Gothic. 1 Press [MENU]. 2 Press U or V repeatedly until Font > appears. Font > 3 Press Z. 4 Press U or V repeatedly until >Font Select > appears. 5 Check that Internal is displayed and press Z. >Font Select > Internal 6 Press U or V repeatedly until >>Pitch appears. >>Pitch 10.00 cpi 7 Press [OK]. A blinking cursor ( _ ) appears. >>Pitch 10.00 cpi 8 Press U or V to increase or decrease the value of the figure where the cursor is blinking. The character pitch can be set between 0.44 and 99.99 characters per inch, in 0.01 character-per-inch increments. You can use Z and Y to move the cursor right and left. 9 When the desired size is displayed, press [OK]. 10 Press [MENU]. The message display returns to Ready. Setting the character code set You can change the character code set. Available character code sets vary depending on the current font. (The default character code set is IBM PC8.) 1 Press [MENU]. 2 Press U or V repeatedly until Font > appears. Font > 3 Press Z. 2-48 ADVANCED OPERATION GUIDE
![](/manual_guide/products/kyocera-fs9130dn-fs9130dn9530dn-operation-guide-advanced-rev11-7add38e/76.png)