KitchenAid KGRS308BSS Use & Care Guide - Page 12

Roll-Out Rack The roll-out rack allows easy access to position and remove food in the oven. The roll-out rack will fit in all positions except the top rack position 7. Open Position To Insert Roll-Out Rack 1. Angle the front of the rack assembly up and insert the rack frame into the "V" cutout in the rack guides of the oven cavity. A B A. Rack frame B. Sliding rack NOTE: To fully extend the roll-out rack, pull the sliding rack forward, and continue pulling until the rack frame slides forward. A B A. Sliding rack B. Rack frame Closed and Engaged Position A B A. "V" cutout B. Rack guides 2. Keep rack assembly lifted up at an angle and push in to bypass the lower "V" cutout. 3. Lower the front of the rack assembly and gently slide rack assembly into oven, bypassing the "V" cutouts. Push the rack assembly to the back of the oven until it stops. AB B A. Rack frame B. Sliding rack A A. "V" cutout B. Rack guides To Remove Roll-out Rack 1. Push the sliding rack in completely so that it is in the closed and engaged position. A 2. Using 2 hands, gently pull the sliding rack and the rack frame at the same time to the "V" cutout. Angle the rack so that the front is higher than the back, and gently pull rack past "V" cutout and then out of the oven. To avoid damage to the sliding rack, do not place more than 25 lbs (11.4 kg) on the rack. Do not clean the roll-out rack in a dishwasher. It may remove the rack's lubricant and affect its ability to slide. See the "General Cleaning" section for more information. Oven Vent The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Blocking or covering the oven vent will cause poor air circulation, affecting cooking and cleaning results. Do not set plastics, paper or other items that could melt or burn near the oven vent. A. Oven vent 12