KitchenAid KFGC558JPA Installation Instructions - Page 22
Natural Gas Conversion, Complete Installation, To Convert Gas Pressure Regulator from Propane
View all KitchenAid KFGC558JPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Complete Installation 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic Ignition System" section for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LO" setting for each range burner. Checking for proper range burner flame is very important. The small inner cone should have a very distinct blue flame 1/4" (6.4 mm) to 1/2" (1.3 cm) long. The outer cone is not as distinct as the inner cone. Propane gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. Natural Gas Conversion WARNING To Convert Gas Pressure Regulator from Propane to Natural Gas NOTE: Door must be removed in order to remove or replace kick plate. Refer to the "Remove Door" section. 1. Lift the kick plate up and off of the kick plate tab. A B C A. Kick plate B. Kick plate tab C. Kick plate slot 2. Gently lay kick plate aside to avoid scratching the stainless steel. 3. Locate the gas pressure regulator at the left rear of the range. Tip Over Hazard A child or adult can tip the range and be killed. Install anti-tip bracket to floor or wall per installation instructions. Slide range back so rear range foot is engaged in the slot of the anti-tip bracket. Re-engage anti-tip bracket if range is moved. Do not operate range without anti-tip bracket installed and engaged. Failure to follow these instructions can result in death or serious burns to children and adults. 1. Turn the manual shut-off valve to the closed position. B A C A. To range B. Shut-off valve (closed position) C. Gas supply line 2. Unplug range or disconnect power. A A. Gas pressure regulator 4. Remove the gas pressure regulator cap by using a large flat-blade screwdriver, turning the regulator cap counterclockwise. NOTE: Do not remove the spring beneath the cap. 22