Kenwood VR-4900 User Manual 1 - Page 4

CHANNEL SPACE / DE-EMPHASIS Switch Not present for USA, Canada and Australia The CHANNEL SPACE/ DE-EMPHASIS switch on the rear panel is set to the correct setting that prevails in the area to which the unit is shipped. However, if the CHANNEL SPACE/ DE-EMPHASIS setting is not matched to the area where the unit is to be used; for instance, if you move from area 1 to area 2 as shown in the table to the right or vice versa, desired reception of AM/ FM broadcasts is not expected. In this case, change the CHANNEL SPACE/ DEEMPHASIS setting in accordance with the area corresponding to the table. The CHANNEL SPACE/ DE-EMPHASIS is switched over at the same time. • iv When changing the setting of the CHANNEL SPACE/ DE-EMPHASIS switch, first unplug the power cord, and then reset the switch, plug the power cord back in, and turn the power switch on. Area CHANNEL DE- SPACE freq. EMPHASIS USA, Canada, 1 and South American Countries FM : 100 kHz AM : 10 kHz 75 µs 2 Other Countries FM : 50 kHz AM : 9 kHz 50 µs CHANNEL SPACE DE-EMPHASIS switch ND AM 50 µs FM 50kHz AM 9kHz DE-EMPHASIS CHANNEL SPACE 75 µs FM 100kHz AM 10kHz Unpacking Unpack your new receiver carefully and make sure that all the accessories are present: Remote control unit (PowerTouch) ENTER CONFIRM UP ME VOLU DOWN CONTRAST ON/STANDBY REMOTE OFF Batteries C (LR-14) × 4 (for VR-4900/VR-4700) AA (LR-6) × 6 (for KRF-V9993D) AM Loop Antenna FM Antenna RF remote Antenna (VR-4900/VR-4700 only) If any accessories are missing, or if the receiver is damaged or fails to operate, notify your dealer immediately. If your receiver was shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing materials in case you need to move or ship the receiver in the future.