Kenwood NX-410 User Manual 1 - Page 41

Compander Busy Channel Lockout Control Channel Hunt

Get Kenwood NX-410 PDF manuals and user guides View all Kenwood NX-410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 41 highlights

COMPANDER If programmed by your dealer for a channel, the compander will remove excessive noise from transmitted signals, to provide higher clarity of signals. Note: The COMPANDER is used only in analog operation. BUSY CHANNEL LOCKOUT (BCL) On Conventional channels, if BCL is set up by your dealer, you will be unable to transmit if the channel is already in use. Use a different channel or wait until the channel becomes free. If BCL Override has been programmed, you can transmit over the current signal: 1 Press and hold the PTT switch. • If the channel is already in use, a warning tone will sound. 2 Quickly release and then press the PTT switch again. 3 Speak into the transceiver as you would during a normal call. CONTROL CHANNEL HUNT On digital Trunking channels, the transceiver automatically searches for a control channel. • While searching for a control channel, the antenna icon will flash and no signals can be received. PTT ID PTT ID is the transceiver unique ID code which is sent each time the PTT switch is pressed and/or released. Note: PTT ID can be made only in analog operation. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
28
C
OMPANDER
If programmed by your dealer for a channel, the compander
will remove excessive noise from transmitted signals, to
provide higher clarity of signals.
Note:
The COMPANDER is used only in analog operation.
B
USY
C
HANNEL
L
OCKOUT
(BCL)
On Conventional channels, if BCL is set up by your dealer, you
will be unable to transmit if the channel is already in use.
Use
a different channel or wait until the channel becomes free.
If BCL Override has been programmed, you can transmit over
the current signal:
1
Press and hold the
PTT
switch.
•
If the channel is already in use, a warning tone will sound.
2
Quickly release and then press the
PTT
switch again.
3
Speak into the transceiver as you would during a normal
call.
C
ONTROL
C
HANNEL
H
UNT
On digital Trunking channels, the transceiver automatically
searches for a control channel.
•
While searching for a control channel, the antenna icon will flash
and no signals can be received.
PTT ID
PTT ID is the transceiver unique ID code which is sent each
time the
PTT
switch is pressed and/or released.
Note:
PTT ID can be made only in analog operation.