Kenwood NX-410 User Manual 1 - Page 16

Nstalling, Niversal, Onnector, Ptional, Peaker, Icrophone, Eadset

Get Kenwood NX-410 PDF manuals and user guides View all Kenwood NX-410 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

INSTALLING THE BELT CLIP Attach the belt clip using the supplied 3 x 8 mm screws. Note: If the belt clip is not installed, its mounting location may get hot during continuous transmission or when left sitting in a hot environment. Belt clip 3 x 8 mm screws Do not use glue which is designed to prevent screw loosening when installing the belt clip. Acrylic ester, which is contained in these glues, may crack the transceiver's back panel. INSTALLING THE CAP OVER THE UNIVERSAL CONNECTOR Insert the cap into place over the universal connector and secure it in place using the attached screw. MIC Universal connector cap INSTALLING THE (OPTIONAL) SPEAKER/ MICROPHONE OR HEADSET 1 Insert the guide of the speaker/ microphone or headset connector into place over the universal connector. 2 Secure the connector in place using the attached screw. MIC Note: When not using an optional speaker/ microphone or headset, install the cap over the universal connector. Optional speaker/ microphone 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
3
Do not use glue which is designed to prevent screw loosening when
installing the belt clip.
Acrylic ester, which is contained in these
glues, may crack the transceiver’s back panel.
I
NSTALLING
THE
C
AP
OVER
THE
U
NIVERSAL
C
ONNECTOR
I
NSTALLING
THE
B
ELT
C
LIP
Attach the belt clip using the
supplied 3 x 8 mm screws.
Note:
If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
Insert the cap into place over the
universal connector and secure
it in place using the attached
screw.
I
NSTALLING
THE
(O
PTIONAL
) S
PEAKER
/ M
ICROPHONE
OR
H
EADSET
1
Insert the guide of the
speaker/ microphone or
headset connector into place
over the universal connector.
2
Secure the connector in place
using the attached screw.
Note:
When not using an optional
speaker/ microphone or headset,
install the cap over the universal
connector.
3 x 8 mm screws
Belt clip
Optional
speaker/ microphone
Universal
connector cap