Invacare CRFAT Owners Manual - Page 50
Adjusting the Camber Tube, may occur.
View all Invacare CRFAT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
SECTION 8-WHEELS Adjusting the Camber Tube ƽ WARNING STANDARD and axle tube clamps - Make sure the hex screws are securely tightened before using the wheelchair, otherwise injury or damage to the wheelchair may occur. NOTE: For this procedure, refer to FIGURE 8.12. Stand behind the wheelchair to determine left or right. 1. Loosen, but DO NOT remove the four socket screws camber tube clamps. 2. Using an ʺLʺ square, rotate the axle tube until the flat edge of the camber tube is at a 90° angle with the ground/floor. 3. Securely tighten the four socket screws camber tube clamps. 4. Determine the toe in/toe out of the wheelchair. Refer to Adjusting Wheelbase Length (Adjusting Center of Gravity) on page 44. Flat Edge of Camber Tube (Place "L" Square Here) "L" Square Here (90° Angle) Ground/ Floor FIGURE 8.12 Adjusting the Camber Tube Crossfire™Series Wheelchairs 50 Part No 1134872