Intermec IF61 GPIO Terminal Block User's Guide - Page 11
Connecting To the IF5, IF30, and IF61 Readers., Control Port.
View all Intermec IF61 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5 Route the control wiring through the sleeve, split ring, and bushing, and into the terminal block through the strain relief connector body. Strain relief connector body Bushing Split ring To industrial controls Sleeve 6 Connect the control wiring to the appropriate terminals inside the terminal block. For more information, see the next section, "Connecting To the IF5, IF30, and IF61 Readers." 7 Install the bushing, split ring, and sleeve on the strain relief connector body (finger tighten only). 8 Install the top cover. 9 Connect the GPIO cable to the terminal block serial port and to the reader as follows: • For the IF61, connect the cable (P/N 236-057-001) to the GPIO port. • For the IF5 or IF30, connect the cable (P/N 236-057-001) to the Control Port. • For the IV7, connect the cable (P/N 236-089-001) to the Data Port on the IV7 and to the COM port on the host PC. GPIO Terminal Block User's Guide 11