InSinkErator Model H-778 Owners Manual - Page 6
Manual del usuario
View all InSinkErator Model H-778 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
TROUBLESHOOTING PROBLEM Water and steam spits forcefully from spout without turning on the dispenser faucet. POSSIBLE CAUSE • Unit is boiling. May be normal during initial setup. WHAT TO DO • Activate faucet lever to release some water from the tank. • Adjust water temperature using dial on tank front. Remember that at higher altitudes, water boils at lower temperatures. Water is not hot. • The unit may not be plugged in. • The electric outlet is inoperative. • Make sure the unit is connected to a properly grounded electric outlet. • Make sure the circuit breaker or fuses are functioning properly. • Check that the outlet is not switched off. Water is too hot or not hot enough. • Thermostat is not adjusted to your needs. Water comes out the vent instead of spout. • Outlet tube is blocked. • A djust the thermostat slowly, then activate faucet handle for 20 seconds to bring in fresh water to be heated at the new setting. Allow 5-7 minutes for water to reach new temperature. • Check that outlet tube is not kinked, twisted or pinched. • Unscrew spout end piece and clean out any debris. Water is dripping from the spout/vent intermittently. • The expansion chamber isn't draining properly due to low water pressure. • The spout is blocked. • Unplug the unit. If the dripping doesn't stop after a few minutes, check the supply valve to ensure that is fully open and there are no obstructions in the water line reducing the pressure below 30 psi (i.e., a poorly mounted saddle valve, a clogged water filter, or a partially opened shut-off valve). • Unscrew spout end piece and clean out any debris. Water is dripping from the spout/vent constantly. • Debris in the water line may be • Unscrew spout end piece and clean out any debris. in the faucet valve seat causing a slow water leak. • Activate faucet lever 7-10 times to flush faucet & lines. Water discoloration/ rusty appearance. • Corrosion of unit. • Unplug and drain unit as described in the Seasonal Storage/ Drainage Section on page 8 of this manual. If the water discoloration remains after draining and refilling unit, discontinue use and contact an authorized InSinkErator service agent. If you are still experiencing trouble, visit www.insinkerator.com/foodservice or call 1-800-845-8345. An instant hot water dispenser, like any water heater, has a limited life and will eventually fail. To avoid possible property damage, this instant hot water dispenser should be regularly examined for leakage and replaced when necessary. A drain pan, plumbed to an appropriate drain or outfitted with a leak detector, should be used in those applications where any leakage could cause property damage. C1300 H778 Dispensador de agua caliente instantánea Manual del usuario Instalación, cuidado y uso Installation, Care & Use Installation, soin et utilisation 10