Hotpoint RGB533DEPBB Owners Manual - Page 21

GEApplianees.com Grid Broiler Pan and Grid After broiling, remove file broiler pan from Tile broiler pan and grid may be cleaned the oven. Remove tile grid from tile pan. with a commercial oven cleaneL Carefldly pour out grease from the pan t_ Both tile broiler pan and grid can also be into a proper conmineL Wash and rinse cleaned in a dishwasheL w the broiler pan and grid ill hot wamr with a soap-filled or plastic scoudng pad. Do not store a soiled broiler pan and grid If food has burned on, sprinkle file grid anDvhere in tile range. PaN with demxgent while hot and cover with A CAUTIOND: oncele,an,he,Toiler wet paper towels or a dishcloth. Soaking tile pan will xemove burnedi:iiiii! Removable Broiler Drawer (on some models) Toremove: Toreplace: [-]-] When tile broiler is cool, remove tile grid and pan. Pull tile broiler drawer out until it stops, then push it back in about one inch. Hold tile broiler drawer ill file xMsed position as you slide it parta,vay into die range. Then lower tile drawer and push it complemly closed. [_ Grasp tile handle, lift and pull tile broiler drawer out. Clean tile broiler drawer with hot soap), wateL iii,ii_¸}iidiiiil i?,::i_i,i2{{_ii Vent appearance and location vary. Oven Air Vents Never block tile vents (air openings) of die range. They provide file mr inlet and outlet that are necessm T for tile range m opemm properly with correct combustion. Air openings are locamd at tile rear of file cooktop, at file mp and bottom of tile oven doox; and at the bottom of tile range, under the kick panel or broiler drawer (depending on tile model). Pull the knob straight off the stem. Lower Control Panel (Front Manifold Panel) and Knobs It's a good idea to wipe file conuol panel after each use of file oven. Use a damp cloth m clean or rinse. Fox cleaning, use mild soap and water or a 50/50 solution of vinegar and wamL Fox rinsing, use clean WamL Polish dxT with a soft cloth. Do not use abrasive cleansexs, strong liquid cleaners, plastic scouring pads or oven cleaners on tile control panel-they will damage the finish. Do not bend lmobs by pulling them up or down or by hanging a towel or other such loads. This can damage tile gas valve shaft. Tile control knobs may be removed for easier cleaning. Make sure tile knobs are ill tile OFF positions and pull them straight off tile stems for cleaning. Tile knobs can be cleaned in a dishwasher or they may also be washed with soap and watex. Make sure tile insides of the knobs are dry before replacing. Replace tile knobs in tile OFFposition to ensure proper placement. Metal parts can be cleaned with soap and wamx: Do not use smel wool, abrasives, ammonia, acids or commercial oven cleanex_. Dry wifll a soft clodl. 27