Hoover F5835 Manual - Page 4
Attach upper handle, Attach tool holder - model
View all Hoover F5835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
The assembled cleaner will look like this 1-2 drawing. 1-3 A Attach upper handle Remove clean solution tank (upper tank) from deep cleaner. 1-4 1-5 B With cord hook (A) to back of deep cleaner, push upper handle down onto lower handle. Push bolts into holes on front of handle. If bolts will not go through hole easily handle is not pushed completely down. 1-6 C Attach hose holder Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure bolts are through holes. Place nuts in recessed areas on back of hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver. Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience. 1-7 1-8 When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod in place. 1-9 D Attach tool holder Remove tool and taped screw from holder. Insert projections on holder into slots on back of cleaner. 4 Slide holder down into place. Insert screw at (D) and tighten with a Phillips screwdriver. Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.