Honeywell IK8560EEKITE User Guide - Page 60

To chose another mode, tap Setup > Decode Mode. A checkmark appears next to the selected mode. There are three options: 1. Full Omni/Standard This is the default scan mode. The image engine looks for any bar code within range. 2. Quick Omni The image engine attempts to decode any enabled barcode while searching a reduced area of the image. By searching for a barcode in a reduced area, based around the center of the image, scanning performance may be improved if the barcode label is found close to the center in the captured image used by the scan engine. 3. Aggressive Linear Decoding The image engine attempts to decode only enabled 1D linear barcodes. Symbologies The Scan Demo can decode a bar code only if its bar code symbology is selected in the symbologies list. To see this list, tap Setup > Symbologies. The symbologies with a checkmark are the symbologies currently selected. The Scan Demo defaults to the Default Bar Code Symbologies on page 6-1. Enabling and Disabling Symbologies To enable a symbology, select it in the list. To disable a symbology, de-select it in the list. You can select and de-select more than one symbology at a time. When you are done enabling and disabling, tap Close and then Yes on the confirmation dialog. In addition to individual, manual selection, the Scan Demo offers you three selection options: All Selects all the symbologies in the list. None De-selects all the symbologies in the list; this button de-selects even the default symbologies. Default Selects only the default symbologies; see Default Bar Code Symbologies on page 6-1. Use this button to return the Scan Demo to the default symbologies after modifications. Tap Close and save your selections. Tap Yes and you are returned to the Scan Demo window. Verify symbology selections by scanning bar codes in the selected symbology(ies) format. Note: Symbology selections apply only to the Scan Demo, not the image engine in general. Centering Centering is a scanning feature that requires the barcode label to be located within a specific area of the imagers field of view in order for the label to be successful decoded. This feature allows the image engine to discriminate between symbols that are located physically close to each other so only one symbol is captured during a decode attempt. Please refer to the Image Kiosk SDK's online help for further details on the use of the centering feature. To enable decode centering, tap Options > Centering. Centering will be applied to your next scan. 6 - 6 Rev B Image Kiosk 8560/8570 User's Guide 3/1/07