HP R8000/3 UPS R6000 ERM Installation Instructions - Page 1
HP R8000/3 Manual
View all HP R8000/3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
hp ups r6000 models extended runtime module installation instructions Read instructions completely before beginning installation procedure. © 1998, 2002 Hewlett-Packard Development Company, L.P. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is provided "as is" without warranty of any kind and is subject to change without notice. The warranties for HP products are set forth in the express limited warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. hp ups r6000 models extended runtime module installation instructions Second Edition (December 2002) Part Number 347219-002 About This Device These instructions show how to install an extended runtime module (ERM). The ERM consists of two battery packs in a 3U chassis. The ERM can be connected directly to an R6000 model or to another ERM. Up to two ERM units can be connected. Depending on the load, one ERM can extend the available UPS runtime by up to 15 minutes. Important Safety Information Before installing this product, read the Important Safety Information document provided. WARNING: • The installation of this product must be performed by individuals who are knowledgeable about the procedures, precautions, and hazards associated with AC and DC power products. • There are no user-serviceable components inside. Regulatory Compliance Identification Numbers For regulatory compliance certifications and identification purposes, the units are assigned a series number, also identified on the Regulatory Compliance label located on the side of the ERM. For certification information, always refer to the series number EO3001B. NOTE: The rating label on the device provides the class (A or B) of the equipment. Class B devices have a Federal Communications Commission (FCC) logo or FCC ID on the label. Class A devices do not have an FCC logo or FCC ID on the label. After you determine the class of the device, refer to the UPS user guide for complete regulatory compliance notices. Weight 69 kg 150 lb WARNING: The ERM weighs 69 kg (150 lb) when fully assembled. To prevent personal injury or damage to the equipment: • Observe local occupational health and safety requirements and guidelines for manual material handling. • Obtain adequate assistance to lift and stabilize the product during installation or removal. The ERM is unstable when not fastened to the rails. Position WARNING: To prevent personal injury or damage to the equipment, take the following precautions when installing the ERM: • The ERM must be installed at the bottom of the rack, with the UPS on top of the ERM. If placed in the rack with existing equipment, the rack must be reconfigured to allow installation of the UPS and ERM at the bottom of the rack. • The ERM must be mounted on the fixed rails included in the ERM kit. Use the rack template tool shipped with the ERM kit to align the rails. 347219- 002