HP R8000/3 UPS R12000 XR Models Installation Instructions - Page 4

Installing the UPS in the Rack

Get HP R8000/3 PDF manuals and user guides View all HP R8000/3 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

5. Insert the back screws into the cage nuts that were installed in step 3. 5. Attach the hold-down bracket (1) to the left rail using the screws in the hardware kit. Attach the hold-down bracket to the UPS using the nuts (2) supplied with the hardware kit. 2 2 Installing the UPS in the Rack Before attempting to install the UPS, review and adhere to all warnings provided in the "Installation Considerations" section of this document. To install the UPS in the rack: 1. With one person on each side of the carton, remove the UPS chassis using the lift-out tray. 2. Gently lower the chassis to the floor in front of the rack. 3. With one person on each side and one person in the rear, lift the chassis to rail level and slide the UPS into place on the mounting rail. 4. Attach the chassis to the rack using the screws and the cage nuts supplied with the rack. NOTE: After installing the UPS chassis, insert remaining screws for support, if any screw holes are unoccupied. 1 WARNING: Do not block the exhaust air vents. 6. Remove the four screws from the rear of the UPS. 7. Attach the hold-down bracket to the UPS with the four screws removed in step 6.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
5.
Insert the back screws into the cage nuts that were installed in
step 3.
Installing the UPS in the Rack
Before attempting to install the UPS, review and adhere to all
warnings provided in the "Installation Considerations" section of
this document.
To install the UPS in the rack:
1.
With one person on each side of the carton, remove the UPS
chassis using the lift-out tray.
2.
Gently lower the chassis to the floor in front of the rack.
3.
With one person on each side and one person in the rear, lift the
chassis to rail level and slide the UPS into place on the
mounting rail.
4.
Attach the chassis to the rack using the screws and the cage
nuts supplied with the rack.
NOTE:
After installing the UPS chassis, insert remaining screws for
support, if any screw holes are unoccupied.
5.
Attach the hold-down bracket (1) to the left rail using the
screws in the hardware kit. Attach the hold-down bracket to the
UPS using the nuts (2) supplied with the hardware kit.
1
2
2
WARNING:
Do not block the exhaust air vents.
6.
Remove the four screws from the rear of the UPS.
7.
Attach the hold-down bracket to the UPS with the four screws
removed in step 6.