HP R8000/3 UPS R12000 XR Models Installation Instructions - Page 1

hp uninterruptible power system r12000 xr models installation instructions Read instructions completely before beginning installation procedure. © 2003 Hewlett-Packard Development Company, L.P. Hewlett-Packard Company shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is provided "as is" without warranty of any kind and is subject to change without notice. The warranties for HP products are set forth in the express limited warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. hp uninterruptible power system r12000 xr models installation instructions Second Edition (December 2002) Part Number 146305-002 146305- 002 Overview These instructions show how to install an uninterruptible power system (UPS). For detailed information about the UPS, refer to the UPS user guide on the Power Products Documentation CD. These instructions assist qualified personnel with the installation of the HP UPS. Save these instructions for future reference. Use the UPS R12000 XR Installation and Startup Package to facilitate the installation and startup of the UPS. Table 1: Installation and Startup Package Numbers Location Package Number United States FM-BPINS-IN Worldwide FP-UPSXR-IN Important Safety Information Before installing this product, read the Important Safety Information guide included with the UPS kit. Regulatory Compliance Information Numbers For regulatory compliance certifications and identification purposes, the UPS models are assigned a series number, also identified on the Regulatory Compliance label located on the side of the UPS. For certification information, always refer to the series number EO3002 and PDU series number EO3024. NOTE: The rating label on the device provides the class (A or B) of the equipment. Class B devices have a Federal Communications Commission (FCC) logo or FCC ID on the label. Class A devices do not have an FCC logo or FCC ID on the label. After you determine the class of the device, refer to the UPS user guide for complete regulatory compliance notices. Installation Considerations Weight 190 kg 420 lb WARNING: To reduce the risk of personal injury or damage to the equipment: • Have the floor-loading requirements evaluated by a facilities engineer before installation. • Observe local occupational health and safety requirements and guidelines for manual material handling. • Obtain adequate assistance to lift and stabilize the product during installation or removal. The UPS will be unstable when not fastened to the rails. • Remove all batteries and electronics modules to reduce the overall weight of the UPS chassis. • Use three people to lift and place the UPS in the rack. Table 2: Component Weights Component Weight Chassis 43 kg (95 lb) Electronics modules (4) 9.5 kg (21 lb) each Battery modules (4) 27 kg (60 lb) each Fully assembled UPS 190 kg (420 lb)