HP R7000 UPS R1500 XR Models Installation Instructions - Page 4

Installing the UPS in the Rack, Completing the UPS Assembly

Get HP R7000 PDF manuals and user guides View all HP R7000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

4. Insert the screws supplied in the UPS kit through each rack-mounting rail and into the front of each rack. 5. Insert the screws into the back of each rail and through the cage nuts that were installed in step 3. 6. Install the rear stabalization bracket. Installing the UPS in the Rack Before attempting to install the UPS, review and adhere to all warnings provided in the "Important Safety Information" section of this document. To install the UPS in the rack: 1. With one person on each side of the carton, remove the UPS chassis using the lift-out tray. 2. Gently lower the chassis to the floor in front of the rack. 3. Cut the band holding the chassis, freeing it from the lift-out tray. 4. With one person on each side, lift the chassis to rail level and slide it into place on the mounting rail. 5. Attach the chassis to the rack using the screws and the cage nuts supplied with the rack. NOTE: After installing the UPS chassis, insert additional screws for support if any screw holes are unoccupied. Completing the UPS Assembly Connecting the Communications Port The UPS includes a communications port that allows the unit to exchange data with the host computer. IMPORTANT: Power management software requires the communications port to be appropriately cabled to the host computer. Connect the UPS/computer interface cable (supplied) from the communications port on the UPS to the appropriate communications port on the host computer. CAUTION: Use only the specific cable supplied with the UPS to connect the communications port to the host computer.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
4.
Insert the screws supplied in the UPS kit through each
rack-mounting rail and into the front of each rack.
5.
Insert the screws into the back of each rail and through the cage
nuts that were installed in step 3.
6. Install the rear stabalization bracket.
Installing the UPS in the Rack
Before attempting to install the UPS, review and adhere to all
warnings provided in the “Important Safety Information” section
of this document.
To install the UPS in the rack:
1.
With one person on each side of the carton, remove the UPS
chassis using the lift-out tray.
2.
Gently lower the chassis to the floor in front of the rack.
3.
Cut the band holding the chassis, freeing it from the
lift-out tray.
4.
With one person on each side, lift the chassis to rail level and
slide it into place on the mounting rail.
5.
Attach the chassis to the rack using the screws and the cage
nuts supplied with the rack.
NOTE:
After installing the UPS chassis, insert additional screws for support
if any screw holes are unoccupied.
Completing the UPS Assembly
Connecting the Communications Port
The UPS includes a communications port that allows the unit to
exchange data with the host computer.
IMPORTANT:
Power management software requires the communications
port to be appropriately cabled to the host computer.
Connect the UPS/computer interface cable (supplied) from the
communications port on the UPS to the appropriate
communications port on the host computer.
CAUTION:
Use only the specific cable supplied with the UPS to
connect the communications port to the host computer.