HP Indigo W7200 Baseline procedure -- CA393-03500 Rev 04 - Page 9
rubber seal is well mounted, and sealing the gap.
View all HP Indigo W7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
10. Check that there is no gap between the external heater hood and rear press wall. Figure 2-9 Seal between the external heater hood and rear press wall 11. At the press rear, verify that the external heater hood fan is aligned with the suction duct. Verify that the rubber seal is well mounted, and sealing the gap. Figure 2-10 External heater hood fan seal 1 Suction duct 2 Fan 3 Seal Press in Shutdown 7
10.
Check that there is no gap between the external heater hood and rear press wall.
Figure 2-9
Seal between the external heater hood and rear press wall
11.
At the press rear, verify that the external heater hood fan is aligned with the suction duct. Verify that the
rubber seal is well mounted, and sealing the gap.
Figure 2-10
External heater hood fan seal
1
Suction duct
3
Seal
2
Fan
Press in Shutdown
7